Check Weighing Operation - Detecto WPB Series Owner's Manual

b (LiM-BZ) – Enable or Disable Check Weighing Beeper
1. With the display showing
2. The display will change to show the current setting.
3. If the current setting is acceptable, press the
weight display.
4. If the current setting is not acceptable, press the
then press the
Allowable settings for the check weighing beeper are:
b (LiM-BZ)
(LiM-MU)
Check Weighing must be enabled before operations can begin. Perform the following to
enable check weighing:
1. If the scale is not on, press the
2. The scale will perform a display test and then change to the weight display.
3. Press the key to enable check weighing.
4. The scale display will momentarily show C6- on (CHECKING ON), to indicate the
check weighing function has been enabled.
NOTE: The functions of the LEDs and beeper are selected when setting the
Upper and Lower limits. Refer to the set-Li (SET Li) – Set the Check
Weighing Functions setting.
Items that are outside the weight range, (over or under) are identified by turning on an LED,
Hi (for over) or Lo (for under) and if enabled, sounding the beeper. Items that are within the
weight range (between the lower limit and upper limit settings) are identified by turning on the
Ok (for acceptable) LED and if enabled, sounding the beeper.
Weight is Greater than Upper (Hi) Limit Setting
If (LiM-Hi) was selected, the Hi LED is turned on, and the scale will beep (until the
weight is removed), to signal that the weight is greater than the Upper Limit weight setting.
Weight is Less than Lower (Lo) Limit Setting
If (LiM-Lo) was selected, the Lo LED is turned on, and the scale will beep (until the
weight is removed), to signal that the weight is less than the Lower Limit weight setting.
Weight is Acceptable (Ok) Limits
If (LiM-in) was selected, the Ok LED will turn on, and the scale will beep (until the
weight is removed), to signal that the weight is within the acceptable limits (greater than the
lower limit setting and less than the upper limit setting).
12 8525-0380-0M Rev B WPB Series Owner's Manual
CHECK WEIGHING, CONT.
b (LiM-BZ, press the
0
key to save it and return to the weight display.
The beeper is enabled.
The beeper is disabled (muted).

CHECK WEIGHING OPERATION

key to turn it on. If the scale is on, skip to step 3.
0
key to save it and return to the
T
key to toggle the selection and
(between lower limit and upper limit settings)
0
key.