Check Weighing; Setting The Upper And Lower Limit Weights - Detecto WPB Series Owner's Manual

The Model WPB Series Waterproof General Bench Scale has a Check Weighing feature that
allows you to set target weights to ensure that the items being weighed are within a specific
acceptable weight range. Check Weighing must be enabled before you can set the upper
and lower limits, and various other functions. Perform the following to enable check weighing:
1. If the scale is not on, press the
2. The scale will perform a display test and then change to the weight display.
3. Press the key to enable check weighing.
4. The scale display will momentarily show C6- on (CHECKING ON), to indicate the
check weighing function has been enabled.

Setting the Upper and Lower Limit Weights

With the scale showing the weight display, press and hold the
The display will change to set-Hi (SET HI).
(SET HI) – Set the Upper (Hi) Limit
set-Hi
1. With the display showing set-Hi (SET HI), press the
2. The display will change to show the current Upper limit with the first digit flashing.
3. If the current setting is acceptable, press the
lower limit setting, set-Lo (SET Lo).
4. If the current setting is not acceptable, use the
first digit, and then press the
5. Repeat this operation until all digits for the upper limit has been entered, and then
0
press the
set-Lo (SET Lo).
set-Lo (SET Lo) – Set the Lower (Lo) Limit
1. With the display showing set-Lo (SET Lo), press the
2. The display will change to show the current Lower limit with the first digit flashing.
3. If the current setting is acceptable, press the
set-Li (SET Li).
4. If the current setting is not acceptable, use the
first digit, and then press the
5. Repeat this operation until the setting for the lower limit has been entered, and then
0
press the
10 8525-0380-0M Rev B WPB Series Owner's Manual

CHECK WEIGHING

key to turn it on. If the scale is on, skip to step 3.
key to proceed to the next digit position.
key to save it and proceed to the lower limit setting,
key to proceed to the next digit position.
key to save it and proceed to set-Li (SET Li).
key for three (3) seconds.
0
key.
0
key to save it and proceed to the
T key to select a new value for the
0
key.
0
key to save it and proceed to
T key to select a new value for the