Rimage Everest Encore Setup And Installation Manual page 2

Rimage Everest Encore Setup and Installation Guide
4
Attach the Cables
If you are using the Everest as a standalone printer, follow the instructions
below to attach the cables.
-
Important! If you are installing the Everest Encore printer on an
autoloader or AutoPrinter, refer to your product's setup and installation
guide for cabling instructions.
a. Connect the USB cable to the rear of the printer.
b. Connect the other end of the USB cable to the computer's USB port.
c. Connect the power cord to the rear of the printer.
d. For now, leave the power cord disconnected from the power outlet.
Power Cord USB Cable

Note: The Everest printer powers on when the power cord is connected
from the printer to the power outlet. You will power on the printer
during the printer driver installation in step 6.
5
Install the Rimage Software
Before you can operate a standalone Everest printer or an AutoEverest
AutoPrinter, you must install the Rimage software. (The Everest printer driver is
installed in step 6.)
-
Important! If your Everest printer was included with a Rimage embedded
autoloader (including Producer V or Catalyst), all Rimage software,
including the printer driver, is pre-installed on the embedded PC.
a. Insert the Rimage CD Designer Software Suite disc that shipped with the
printer into your computer's disc drive.
b. If the installation does not start automatically, browse to the disc drive
on your computer and open the file named setup.exe.
c. Follow the prompts to install the CD Designer software.
 Note: While it is necessary to install Rimage software to operate the
Encore printer, any software can be used for printing, not just CD
Designer.
2004012_A
6
Install the Everest Printer Driver
a. Make sure that the USB cable is connected from the Everest printer
to your PC.
b. Power on the Everest printer.
• For a standalone printer, connect the power cord from the
printer to the power outlet.
• For an AutoEverest AutoPrinter, power on the AutoPrinter.
The Printer driver installs automatically.
Power Cord USB Cable
7
Learn More
For instructions on how to set the print settings, as well as how to operate and
maintain the Everest Encore printer, refer to the Rimage Everest Encore User
Guide. The user guide is available at www.rimage.com/support.
For additional support and product information, go to
www.rimage.com/support.
Copyright © 2017 Rimage Corporation
Page 2