Remote Jack Pack / Tv Connections & Setup - LG ProCentric 32LV570H Setup Manual

Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093
RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 1). See Installer Menu detailed descriptions for further information.
093 RJP AVAILABLE
TV Connections
Caution: Make these connections ONLY after Master TV Setup and TV cloning procedures
are complete. Also, make sure to use the RJ-45 Control cable from the RJP cable bundle to
make the connection to the TV's RJP port. Do NOT connect a standard Ethernet cable to
the RJP port, as this may damage the TV and network equipment.
Refer to the figure below, and connect the RJ-45 Control cable from the RJP cable bundle to the RJP
port on the TV's rear jack panel. Then, connect HDMI, RGB, and Composite Video/Audio connectors, as
applicable, for the cable bundle.
RGB IN (PC)
Connect RGB connector
from RJP cable bundle
(legacy RJP only).
206-4317 Draft A.2
Reference: Remote Jack Pack / TV Connections & Setup
001
SPEAKER OUT
LINE OUT
OPTICAL
DIGITAL
AUDIO OUT
SERVICE
ONLY
RJP
Connect RJ-45 Control cable
from RJP cable bundle.
LAN RJP Use Only
IN
GAME CONTROL
1
/ MPI
RGB IN (PC)
L R
TV-LINK CFG
VIDEO L/MONO -AUDIO- R
AV IN/AUDIO IN (RGB DVI)
AUDIO/VIDEO IN
Connect Composite Video/Audio
connectors from RJP cable bundle.
(Composite Video on legacy RJP only.)
HDMI IN 1
Connect HDMI connector
from RJP cable bundle.
RESET
ANTENNA /
CABLE IN
51