Remote Jack Pack / Tv Connections & Setup - LG 32LT570H Commercial Mode Setup Manual

Reference: Remote Jack Pack / TV Connections & Setup
Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093
RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 1). See Installer Menu detailed descriptions for further information.
093 RJP AVAILABLE
TV Connections
Caution: Make these connections ONLY after Master TV Setup and TV cloning procedures
are complete. Also, make sure to use the RJ45 Control cable from the RJP cable bundle to
make the connection to the TV's RJP port. Do NOT connect a standard Ethernet cable to
the RJP port, as this may damage the TV and network equipment.
Refer to the figure below, and connect the RJ45 Control cable from the RJP cable bundle to the RJP port
on the TV's rear jack panel. Then, connect HDMI, and Composite Video/Audio connectors, as applicable,
for the cable bundle.
SPEAKER OUT
LINE OUT
Note: RGB is not supported on these TV models. If an RGB source is connected to a legacy
RJP, you will see a brief message on-screen to indicate that this device is not supported.
56
001
RJP Use Only
Connect RJ45 Control cable
from RJP cable bundle.
LAN
RJP Use Only
IN
OPTICAL
DIGITAL
1
AUDIO OUT
RS-232C IN (CONTROL&SERVICE)
L
VIDEO L/MONO -AUDIO-
SERVICE ONLY
AV IN / AUDIO IN
AUDIO/VIDEO IN
Connect Composite Video/Audio
connectors from RJP cable bundle.
(Composite Video on legacy RJP only.)
HDMI IN 1
Connect HDMI connector
from RJP cable bundle.
GAME CONTROL
/ MPI
RESET
TV-LINK CFG
R
ANTENNA /
R
CABLE IN
206-4340