– Make a mark on the bleed pipe, dimension -a-, and cut it, with
for example the Brake Line Tool Kit - Pipe Cutter -
VAS6056/2- .
– Clean the Oil Filler - VAS6262A- .
Procedure
Note
The transmission fluid is a permanent filling. For this reason,
♦
a fluid level check is not necessary on this transmission.
A fluid level check does therefore not exist.
♦
If leaks occur at the transmission, the cause is to be deter‐
♦
mined and faults must be corrected.
After that it is necessary to drain all the transmission fluid and
♦
fill it again.
– Raise the vehicle.
– Remove the noise insulation. Refer to ⇒ Body Exterior; Rep.
Gr. 50 ; Noise Insulation .
– Place the Used Oil Collection and Extraction Unit -
SMN372500- or Drip Tray under the transmission.
– Remove the drain plug from the transmission.
– Drain the fluid and then install the drain plug and tighten it.
Note
It is not possible to check the transmission fluid level.
♦
Fill the fluid exactly to the specified quantity.
♦
This assures the transmission is filled correctly.
♦
Underfilling or overfilling the transmission fluid will cause the
♦
transmission to malfunction.
Caution
Risk of damaging the transmission.
♦ Use only the transmission fluid specifically for the 7-speed
DSG® transmission 0AM. It is available as a replacement
part. Refer to the Parts Catalog.
♦ Using other fluids can cause malfunctions or transmission
failure.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
7-Speed Dual Clutch Transmission 0AM - Edition 09.2015
1. Transmission Fluid, Replacing
71