Table 29.Climate Control System Cas Messages - Eclipse 500 System Manual

Section 9. Climate Control
9.9 Crew Alerting System Messages
Table 29. Climate Control System CAS Messages
Message
CABIN ALTITUDE
CABIN dP HIGH
L (R)BLEED AIR OVERHEAT
L (R) PYLON OVERHEAT
CABIN ALTITUDE
CABIN PRESS ON GROUND
L (R) BLEED VALVE FAIL
CABIN ALT HOLD MODE
AIR CONDITIONING FAIL
L (R) BLEED AIR TEMP HIGH
CLIMATE CTRL FAIL
L (R) PYLON TEMP FAULT
L (R) BLEED AIR TEMP
FAULT
AIR SOURCE SW FAULT
AIR SOURCE SELECTOR
CABIN ALT HOLD MODE
Version 2.0 April 2007
Condition
Cabin altitude environment has exceeded
10,000 ft.
Cabin differential pressure exceeded.
Bleed air supply temperature limiting has failed
Left or right pylon overheat detected
Cabin altitude has exceeded 8,750 ft.
Cabin is pressurized on the ground.
Bleed air valve stuck in low flow position or
failed open when commanded closed.
Primary pressurization failed. Backup
controller attempting to hold cabin altitude
constant.
Air conditioning has failed
Bleed air supply temperature is too high.
Normal bleed air temperature control has
failed. L or R bleed air temperature is being
limited by the flow control valves
Indicates failure of either left or right ram air
exhaust valve or the left or right fan air control
valve. Expect degraded bleed air temperature
regulation
The pylon temperature sensor has failed
The bleed air temperature sensor has failed
The air source selector switch has failed
The air source selector is in another position
than NORM.
Cabin altitude hold mode active as selected by
the pilot.
Copyright © — Eclipse Aviation Corporation
Eclipse 5OO Systems Manual
Category
Warning
Warning
Warning
Warning
Caution
Caution
Advisory
Advisory
Advisory
Advisory
Advisory
Advisory
Advisory
Advisory
Status
Status
213