Advertisement
7HOH6PDUW2SWLRQVIURPD7HOHSKRQH
8VLQJD7HOHSKRQHWR&RQWUROWKH6H.XULW\6\VWHPIURP
You can control your security system from a telephone by using TeleSmart.
1. Pick up any telephone handset.
If calling from a remote phone, dial your home number and do step 2 during the
greeting message.
2. Press # , then enter your access code, then press ∗ .
3. Press [1] to activate the security system mode.
Refer to the table shown below for some of the typical security system commands.
Refer to your security system's User Guide for specific commands and procedures.
COMMAND
CHECK STATUS
DISARM SYSTEM
ARM MAXIMUM**
ARM INSTANT
ARM AWAY
ARM STAY
BYPASS A ZONE(S)
CHIME MODE
* You must use a security system user code to perform a security system function.
** Not all control panels support "Maximum" arming mode.
† Depending on the security system installed, zone numbers are entered as either 2- or
3-digit entries. See your installer for the type of zone number entries required for your
system.
Once you enter the Security System Menu from the telephone, you cannot
return to the Main Menu by pressing a key. Instead, TeleSMART
automatically returns to the Main Menu after 10 seconds of no key presses.
PRESS
∗
Code* +
1
Code* +
4
Code* +
7
Code* +
2
Code* +
3
Code* +
+ zone no.
6
Code* +
9
-30-
†
to be bypassed
.RQW
Advertisement
