Advertisement
7ROO6DYHU0HVVDJH%HHSV RSWLRQV
09
10
Aux CID
Keypad CID
NAVIGATION: [∗] = Next Option; [#] = Previous Option; [7] = GOTO prompt; [9] = Exit System.
$ERXWWKH7ROO6DYHU)HDWXUH
The Toll Saver feature lets you call in to the system to check if there are new messages
(determined by the number of rings). This lets you hang up before incurring toll charges.
The Toll Saver feature works in combination with the security system. First, you must turn
Toll Saver on (shown below), but then it becomes active only when the security system is
armed in the AWAY or MAXIMUM mode. The Toll Saver feature is inactive when the
security system is disarmed or when it is armed STAY or INSTANT.
When Toll Saver is active (option is on and system is armed AWAY or
MAXIMUM), the "distinctive ring" feature is automatically disabled.
+RZWR7XUQ7ROO6DYHU2Q2II
463+6%1 13()
8300 7%:) 32
+RZWR&KH.NIRU0HVVDJHVZKLOH7ROO6DYHULV2Q
1.
Call in to the system and listen for the number of rings:
2 rings = There are new messages/memos in one or more of the mailboxes
4 rings = There are no new messages/memos in any of the mailboxes
2.
To save the toll charge if there are no new messages, hang up after the third ring.
$ERXW0HVVDJH%HHSV SKRQHWRQH
The system can alert you to new messages whenever you pick up the telephone
receiver, if desired. If the message beeps feature is turned on and you have new
messages, the system beeps over the dial tone when you pick up the telephone receiver.
When accessing TeleSmart from a telephne, this feature is announced as "phone tone."
+RZWR7XUQ0HVVDJH%HHSV2Q2II
463+6%1 13()
17+ &))4 3**
11
12
Aux Volume
Toll Saver
Toll Saver:
1. Go to the "12-Toll Saver" prompt.
2. To turn the Toll Saver feature on, press [0].
To turn Toll Saver off, press [0] again.
Message Beeps:
1. Go to the "13-Message Beeps" prompt.
2. To turn Message Beeps on, press [0].
To turn Message Beeps off, press [0] again.
-16-
13
14
HF Keypad
Message Beeps
15
16
HF Aux
Handset On/Off
Advertisement
