Advertisement
7HOH6PDUW2SWLRQVIURPD7HOHSKRQH
$ERXW8VLQJD7HOHSKRQHWR&RQWURO7HOH6PDUW
TeleSmart lets you use a telephone to access some of the system's functions and control
the security system. You can control TeleSmart's typical operating functions from a
telephone, but you cannot perform most system programming functions, (which can be
done only from a TeleSmart keypad).
In addition to these restricted telephone functions, the menu structure for accessing these
functions is different from that used with a TeleSmart keypad. Refer to the Telephone
Access Menu Map on the next page to help navigate the menu system.
7R8VH7HOH6PDUW)URPD7HOHSKRQH
1. Pick up any telephone handset (if calling from a remote phone, dial your home number
and do step 2 during the greeting message).
2. Press # , then enter your access code, then press ∗ .
For example, if the access code is "5678": press # [5-6-7-8] ∗ .
3. The Main Menu options are announced in numerical order (see the table below).
Select the desired menu option by pressing the corresponding option number on the
telephone keypad at any time.
NOTE:
While using TeleSMART from a telephone, the system is unable to receive calls.
The following table lists the functions that you can perform from a telephone.
From a Telephone, You Can...
Control the security system
Listen to your messages
Record a memo
Select another mailbox
Record a greeting
Turn privacy on/off
Turn toll saver on/off
Turn the CID display on/off
Turn message beeps (phone tone) on/off
Turn call screening on/off
Refer to the previous sections in this manual for full descriptions of these functions.
By Pressing...
[1] then desired arming command
[2]
[4] then follow the prompts
[6] then enter mailbox number
[7] [2] then follow the prompts
[7] [1] [3]
[7] [1] [4]
[7] [1] [6]
[7] [1] [2] [4]
[7] [1] [2] then follow the prompts
-28-
Advertisement
