TVS Jupiter BS-VI Owner's Manual page 70

Disc brake
1. Remove the axle nut (1) along with a washer.
2. Pull out the axle (2) along with a washer and take
out a spacer from the right side of the wheel.
3. Place a support below the foot board to prevent
the vehicle from falling and lift the vehicle up.
4. Dislocate the wheel disc from caliper assembly
and take out the wheel along with hub drive.
5. Reverse the procedure for reassembling. Ensure
the proper seating of wheel disc in the caliper
assembly and lug on fork leg R to the slot in the
hub drive while reassembling.
1
54
REAR WHEEL REMOVAL AND REASSEMBLY
1. Place the vehicle on the centre stand.
2. Hold the rear brake firmly and remove the wheel
3. Slightly tilt the vehicle and take out the wheel
4. Reassemble the wheel in the reverse order of
2
Always make sure, whenever the wheel is removed, the
axle nuts are tightened properly to the specified torque.
mounting nut (A) along with a washer.
from the rear axle.
removal.
Warning
A