Logic Power Supply; Configuration; Description Of The Sercos Iii Master Module; Diagnosis - Bosch Rexroth NYCe 4000 Instructions Manual

12/19 NYCe 4000 Multi-axis motion control
system

Diagnosis

11.2 Logic power supply

Power supply for the logic of the SERCOS III Master module is connected via the
connector blocks at the rear side of the SERCOS III Master module and is
supplied by the Motion Control Unit in the system housing.

11.3 Configuration

The flash memory on the Motion Control Unit (MCU) contains the gateware and
microware for the logic on the SERCOS III Master module. The flash memory on
the MCU also contains a bootloader to communicate with the NYCe 4000 tools.
With the tools you can download from the PC to the MCU the required firmware
for the MCU and the required gateware and microware for the SERCOS III
Master module installed in the system housing. See for more information the
NYCe 4000 documentation delivered with the NYCe 4000 Software Release.

12 Description of the SERCOS III Master module

The SERCOS III Master module has two blocks of connectors at the rear edge of
the circuit board, which connect the SERCOS III Master module to the
backplane in the system housing. All power supply connections and interface
connections to other modules and headers on the base plate of the system
housing are established via these connector blocks.
The front side of the SERCOS III Master module has a cover plate. On the cover
plate are two LEDs visible. The LEDs are marked "DRV" and "NET". Further, on
the cover plate are two RJ45 SERCOS III network sockets marked "PORT 1" and
"PORT 2".
13 Diagnosis
After the installation of the SERCOS III Master module in the system housing
(which includes an installed Motion Control Unit), and connection of the power
supply, you can check the operation of the SERCOS III Master module.
The "DRV" LED shows the status of the SERCOS III Master module.
Bosch Rexroth AG R911337377_Edition 05