Setup Instructions - UMF Medical 4040-650 Owner's Manual

SETUP INSTRUCTIONS

Models 4040/4070-650-100 (Power100+, Power100)
To Set Up your New Power Table:
PLEASE FOLLOW THESE STEPS COMPLETELY to Ensure that your table functions properly
PLEASE DO NOT PLUG TABLE IN UNTIL PRECEDING STEPS ARE COMPLETED
1. The Table has one (1) Port for the Foot Control in the Front of the Table Base.
2. Locate the Plug Port in the Front of the Table Base.
3. Locate Green Dot on the Left Side of the Port.
4. Locate Green Dot on the Plug end of the Foot Control.
5. Align Green Dot on Plug with Green Dot on Port.
6. Plug in Foot Control completely, ensuring that Yellow 'O' Ring is completely inserted into the port until the
Yellow Color completely disappears.
NOTE: IF YELLOW O- RING IS NOT COMPLETELY INSERTED INTO THE PORT, THE TABLE WILL NOT FUNCTION. THE TABLE
WILL BEEP AND REQUIRE A CONTROL BOX RESET. THIS IS A SAFETY FEATURE.
7. Slide the Round Screw Lock forward over the Port Plug and turn clockwise to tighten. Ensure completely tight.
8. Plug Power Cord into the Port in the Exam Table.
Models 4040/4070-650-200 & 300 (Power200+, Power200, ProGlide300+,
ProGlide300)
To Set Up your New Power Table:
PLEASE FOLLOW THESE STEPS COMPLETELY to Ensure that your table functions properly
PLEASE DO NOT PLUG TABLE IN UNTIL PRECEDING STEPS ARE COMPLETED
1. The Table has three (3) Ports for the Hand and Foot Controls in the Table Base: two (2) located at the Rear and one (1)
located at the Front.
2. Locate the Ports and choose which ports you prefer to place Hand and Foot Controls.
3. Start with installing the Hand Control.
4. Locate the Green Dot on the Port on the Table Base.
5. Locate Green Dot on the Plug end of the Hand Control.
6. Align Green Dot on Plug with Green Dot on Port.
7. Plug in Hand Control completely, ensuring that Yellow 'O' Ring is completely inserted into the port until the Yellow Color
completely disappears.
NOTE: IF YELLOW O- RING IS NOT COMPLETELY INSERTED INTO THE PORT, THE TABLE WILL NOT FUNCTION. THE TABLE WILL
BEEP AND REQUIRE A CONTROL BOX RESET. THIS IS A SAFETY FEATURE.
8. Slide the Round Screw Lock forward over the Port Plug and turn clockwise to tighten. Ensure completely tight.
9. Choose the Port in the Front or Rear of the Table for your Foot Control.
10. Locate Green Dot on the Port
11. Locate Green Dot on the Plug end of the Foot Control.
12. Align Green Dot on Plug with Green Dot on Port.
13. Plug in Foot Control completely, ensuring that Yellow 'O' Ring is completely inserted into the port until the Yellow Color
completely disappears.
3-00077-0318A
3-00077-0318A
Page 19