Table of Contents
Advertisement
SETUP INSTRUCTIONS
Models 4040/4070-650-100 (Power100+, Power 100)
To set up your New Power Table:
PLEASE FOLLOW THESE STEPS COMPLETELY to ensure
that your table functions properly PLEASE DO NOT PLUG
TABLE IN UNTIL PRECEDING STEPS ARE COMPLETED.
1. The table has one (1) port for the foot control in the
front of the table base.
2. Locate the plug port in the front of the table base.
3. Locate green dot on the left side of the port.
4. Locate green dot on the plug end of the foot control.
5. Align green dot on plug with green dot on port.
6. Plug in foot control completely, ensuring that yellow
'O' ring is completely inserted into the port until the
yellow color completely disappears.
NOTE: IF YELLOW O-RING IS NOT COMPLETELY
INSERTED INTO THE PORT, THE TABLE WILL NOT
FUNCTION. THE TABLE WILL BEEP AND REQUIRE
A CONTROL BOX RESET. THIS IS A SAFETY FEATURE.
7. Slide the round crew lock forward over the port plug
and turn clockwise to tighten. Ensure completely tight.
8. Plug power cord into the port in the exam table.
Models 4040/4070-650-200 & 300
(Power200+, Power 200, ProGlide300+, ProGlide300)
To set up your New Power Table:
PLEASE FOLLOW THESE STEPS COMPLETELY to ensure
that your table functions properly PLEASE DO NOT PLUG
TABLE IN UNTIL PRECEDING STEPS ARE COMPLETED.
1. The table has three (3) ports for the hand and foot control
in the table base: two (2) located at the rear and one (1)
located at the front.
2. Locate the ports and choose which ports you prefer to
place hand an foot controls.
3. Start with installing the hand control.
4. Locate the green dot on the port on the table base.
5. Locate green dot on the plug end of the hand control.
6. Align green dot on plug with green dot on port.
7. Plug in hand control completely, ensuring that yellow
'O' ring is completely inserted into the port until the
yellow color completely disappears.
NOTE: IF YELLOW O-RING IS NOT COMPLETELY
INSERTED INTO THE PORT, THE TABLE WILL NOT
FUNCTION. THE TABLE WILL BEEP AND REQUIRE
A CONTROL BOX RESET. THIS IS A SAFETY FEATURE.
8. Slide the round crew lock forward over the port plug
and turn clockwise to tighten. Ensure completely tight.
9. Choose the port in the front or rear of the table for
your foot control.
10. Locate green dot on the port.
11. Locate green dot on the plug end of the foot control.
12. Align green dot on plug with green dot on port.
13. Plug in foot control completely, ensuring that yellow
'O' ring is completely inserted into the port until the
yellow color completely disappears.
Part number: #3-2459LT Rev B
19
Advertisement
Table of Contents
