Setup Instructions - UMF Medical 4010-650 Owner's Manual

SETUP INSTRUCTIONS

Models 4010/4011/5016-650-100
(Power4010, Power4011, Power5016)
To set up your New Power Table:
PLEASE FOLLOW THESE STEPS COMPLETELY to ensure
that your table functions properly PLEASE DO NOT PLUG
TABLE IN UNTIL PRECEDING STEPS ARE COMPLETED.
1. Locate the hand control port at the rear of the table base.
2. Locate green dot on the port at the rear of the table base.
3. Locate green dot on the plug end of the hand control.
4. Align green dot on plug with green dot on port.
5. Plug in hand control completely, ensuring that yellow
'O' ring is completely inserted into the port until the
yellow color completely disappears.
NOTE: IF YELLOW O-RING IS NOT COMPLETELY
INSERTED INTO THE PORT, THE TABLE WILL NOT
FUNCTION. THE TABLE WILL BEEP AND REQUIRE
A CONTROL BOX RESET. THIS IS A SAFETY FEATURE.
6. Slide the round crew lock forward over the port plug
and turn clockwise to tighten. Ensure completely tight.
7. Plug power cord into the port in the exam table.
8. Plug power cord into the wall outlet.
Models 4010/4011/5016-650-200 & 300
(Power4010p, Power4011p, Power5016p, ProGlide4010,
ProGlide4011, ProGlide5016)
To set up your New Power Table:
PLEASE FOLLOW THESE STEPS COMPLETELY to ensure
that your table functions properly PLEASE DO NOT PLUG
TABLE IN UNTIL PRECEDING STEPS ARE COMPLETED.
1. The table has two (2) ports for the foot control, one (1)
located at the front and one (1) located at the rear. Locate the
ports and choose which port to plug in your foot control.
2. The table has one (1) port for the hand control located in the
rear of the table base.
3. Start with installing the hand control.
4. Locate the hand control port at the rear of the table base.
5. Locate green dot on the port at the rear of the table base.
6. Locate green dot on the plug end of the hand control.
7. Align green dot on plug with green dot on port.
8. Plug in hand control completely, ensuring that yellow
'O' ring is completely inserted into the port until the
yellow color completely disappears.
NOTE: IF YELLOW O-RING IS NOT COMPLETELY
INSERTED INTO THE PORT, THE TABLE WILL NOT
FUNCTION. THE TABLE WILL BEEP AND REQUIRE
A CONTROL BOX RESET. THIS IS A SAFETY FEATURE.
9. Slide the round crew lock forward over the port plug
and turn clockwise to tighten. Ensure completely tight.
10. Choose the port in the front or rear of the table for
your foot control.
11. Locate green dot on the port.
12. Locate green dot on the plug end of the foot control.
13. Align green dot on plug with green dot on port.
14. Plug in foot control completely, ensuring that yellow
'O' ring is completely inserted into the port until the
yellow color completely disappears.
NOTE: IF YELLOW O-RING IS NOT COMPLETELY
INSERTED INTO THE PORT, THE TABLE WILL NOT
FUNCTION. THE TABLE WILL BEEP AND REQUIRE
A CONTROL BOX RESET. THIS IS A SAFETY FEATURE.
15. Slide the round crew lock forward over the port plug
and turn clockwise to tighten. Ensure completely tight.
16. Plug power cord into the port in the exam table
17. Plug power cord into the wall outlet
Part number: #3-2379LT Rev. A
18