UMF Medical 4040-650 Owner's Manual page 8

FEATURES AND OPERATION
HAND CONTROL - MEMORY PROGRAMMING & SPECIAL FUNCTIONS
- Two programmable positions for storing commonly use table positions.
To Program:
1) Move table to desired position for memory storage.
2) Press and Hold (approximately 3 seconds) desired memory position button (M1 or M2) in which table position is
to be stored. An audible double beep should be heard indicating table position has been programmed.
3) To use memory function, Press and Hold the memory button (M1 or M2) for 1 second. Table will return to
programmed position.
Holding the memory button (M1 or M2) for 3 seconds when performing step 3 will cause the memory button to
re-program to the current position of the table.
- Stops table movement when any impulse movements (HOME, Memory Function M1 or M2) are being used.
Pressing any button on the hand or foot control will cancel table movement.
Simultaneous movement
- Press any combination of buttons for simultaneous movement of multiple functions
3-00077-0318A
Simultaneous Movement
(shown as an example)
Memory Positions
4040-650
Stop Control
4070-650
Page 8