Basic Operation; How To Feed Power; How To Switch Audio Modes; How To Adjust The Volume - Toyota AUDIO 1-DIN Owner's Manual

Table of Contents

Advertisement

BASIC OPERATION

HOW TO FEED POWER

The AUDIO system works only when the ignition switch is ACC or ON.
(1) Press the MODE/POWER BUTTON
To turn the power off, press and hold down the switch for 1 second or
more.
NOTE
If the MODE/POWER BUTTON
is pressed while listening to music in AUDIO
mode, the power is turned OFF. When you press the MODE/POWER BUTTON
again, the AUDIO system continues using the last mode just before it was
turned off.
(1) Press the MODE/POWER BUTTON
(1) Press the VOLUME CONTROL BUTTON
to turn the power on.
- 6 -

HOW TO SWITCH AUDIO MODES

Each time you press the MODE/POWER BUTTON
mode changes as shown below.
*1 *2
*3
AM
FM
DISC
USB
*1 The content to be displayed varies depending on the data stored
in the CD. (CD/MP3/WMA)
*2 These modes are skipped when a CD is not inserted.
*3 This mode is skipped when a USB is not connected.
*4 This mode is skipped when a device is not connected.

HOW TO ADJUST THE VOLUME

Press the VOLUME CONTROL ( ) BUTTON
Press the VOLUME CONTROL ( ) BUTTON
To adjust the volume by 1 step at a time, press the VOLUME CONTROL
( ) or ( ) BUTTON
for less than 1 second.
To adjust the volume steadily, press and hold down the VOLUME
CONTROL ( ) or ( ) BUTTON
ATTENTION
Turning the power on or off with the volume set to maximum will damage the
equipment and your hearing. Set the volume to a moderate level.
NOTE
You can adjust within a range of 63 (maximum) and 19 (default) and 0.
.
, the audio
*4
AUX
AM...
to adjust the volume.
to increase the volume.
to decrease the volume.
for more than 1 second.

Advertisement

Table of Contents
loading

Table of Contents