Table of Contents
Advertisement
RADIO OPERATION
HOW TO TURN ON THE RADIO
(1) Press the MODE/POWER BUTTON
source "AM", "FM".
The selected mode is shown in the DISPLAY WINDOW
(2) To tune, follow one of the procedures below:
Press the TUNE BUTTON
Press the CH BUTTON
TO TURN OFF THE RADIO
Press the MODE/POWER BUTTON
To turn on the radio, press the button again.
to select the desired radio
.
to turn off the radio.
- 8 -
HOW TO TUNE
MANUAL TUNING
(1) Press the TUNE ( ) or ( ) BUTTON
Each time the button is pressed, the frequency steps up (or down) to select
the station of your choice.
The display should be checked in order to adjust the frequency because AM
radio frequency will range from 9 kHz or FM radio frequency will range from
0.05 MHz.
AUTOMATIC TUNING
(1) Press the TUNE ( ) or ( ) BUTTON
The radio starts searching for stations, and stops when it nds a station.
To cancel, press the button again.
NOTE
When the TUNE (
) BUTTON
frequency side (step up), and to the lower frequency side (step down) when
pressing the TUNE (
) BUTTON
In either case, if the radio cannot nd a station, it continues searching.
The radio will stop searching at a broadcasting station upon reception.
HOW TO STORE STATIONS (PRESET)
You can store up to six preset channels for FM and AM radio.
TUNING TO A PRESET CHANNEL
(1) Press the CH BUTTON
for less than 2 seconds.
(2) Press the TUNE ( ) or ( ) BUTTON
of the preset channel you want to listen to.
For example: "CH1" is displayed in the DISPLAY WINDOW
SAVING TO A PRESET CHANNEL
(1) Tune to the channel number you want to save.
(2) Press the CH BUTTON
for more than 2 seconds.
The frequency ashes in the DISPLAY WINDOW
(3) Press the TUNE ( ) or ( ) BUTTON
want to save.
(4) Press the CH BUTTON
for more than 2 seconds.
The frequency lights up in the DISPLAY WINDOW
saved to a preset channel.
for less than 2 seconds.
for more than 2 seconds.
is pressed, the radio is tuned to the higher
.
, and then select the number
.
.
to select the frequency you
when it has been
Advertisement
Table of Contents
