Disassembly Procedure; Preparation For The Repair Service; How To Remove The Front Panel; How To Remove The Remocon Assy - Mitsubishi Electric EHST17D-VM2D Service Manual

11

DISASSEMBLY PROCEDURE

<Preparation for the repair service>
● Prepare the proper tools.
● Prepare the proper protectors.
● Provide adequate ventilation.
● After stopping the operation of the cylinder and outdoor unit, turn off all the power-supply breaker.
● Discharge the condenser before the work involving the electric parts.
● Allow parts to cool.
● Do not expose the electric parts to water.
● When replacing or servicing water circuit parts, drain system first.
Check individual illustrations and positions of the parts by referring to the parts catalogue.
Some lead wires and pipes are bundled with bands. Cut the bands to undo the fastened pipes and lead wires if necessary. When bundling the
lead wires and pipes again, use new commercially available bands.
When removing the parts associated with water pipe work, drain the cylinder unit as necessary. Refer to "Draining the cylinder unit" on page 26.
When draining the cylinder unit, keep water from splashing on the internal parts (mainly electric parts and insulations).
DISASSEMBLY PROCEDURE

1. How to remove the front panel

(1) Remove the 2 screws at the bottom of the cylinder unit.
(Photo 1-1)
(2) Slightly lift and pull out the front panel from the cylinder
unit. (Photo 1-1)
(3) Disconnect the relay connector connecting from the
remocon assy. (Photo 1-2)
Photo 1-2
Remocon assy

2. How to remove the remocon assy

(1) Remove the front panel. (Refer to Procedure 1.)
(2) Turn the front panel over and remove the remocon
holder by removing the 5 claws. (Photos 2-1 and 2-2)
(3) Slide the main remote controller support upward, then
remove it together with the remocon assy. (Photo 2-2)
(4) Separate the remocon assy from the remocon support.
(Photos 2-1 and 2-3)
Photo 2-1
Remocon support
OCH714A
Photo 2-2
Front panel
Claw
Claws
65
: Indicates the visible parts in the photos/figures.
: Indicates the invisible parts in the photos/figures.
PHOTOS/ FIGURES
Photo 1-1
Remocon assy
Front panel
Connector
Remocon holder
Remocon
assy
Front panel fixing screws
Photo 2-3