Indoor Unit/Wireless Receiver Communication Failure; Wireless Remote Controller/Wireless Receiver Communication Failure - Mitsubishi Electric EHST17D-VM2D Service Manual

Error code Title and display conditions
E1/E2
Main remote controller control board failure
Error code E1 displayed if main remote control-
ler cannot access it is non volatile (non power
dependent) memory.
Error code E2 is displayed when there is a fault
with the main remote controller's internal clock.
J0 Indoor unit/wireless receiver communication
failure
Error code J0 is displayed when the FTC cannot
receive data from the wireless receiver for 1
minute.
J1 to J8 Wireless remote controller/wireless receiver
communication failure
(Reception error)
Error code displayed if wireless receiver receives
no/incomplete data from the wireless remote
controller for 15 consecutive minutes.
The digit after the J refers to the address of the
wireless remote controller that has the error.
E.g. Error code "J3" refers to a communication
fault between the wireless receiver and wireless
remote control with address 3.
EE Combination error between FTC and outdoor unit R410A outdoor unit is combined incorrectly. Check combination of FTC and outdoor unit.
U*, F*, A* Outdoor unit failure
Note: To cancel error codes, please switch system off (press button F4 (RESET) on main remote controller).
OCH714A
Possible Cause
1. Fault with the main remote controller
circuit board
1. Connection fault with wireless receiver-
FTC connection
2. Fault with FTC receiving circuit board
3. Fault with wireless receiver's transmis-
sion circuit board
4. Electrical noise causes interference
with wireless receiver communication
cable.
1. Battery on wireless remote control may
be flat.
2. The wireless remote controller is out of
range of the wireless receiver.
3. Fault with wireless remote controller
transmission circuit board
4. Fault with wireless receiver's reception
circuit board
Outdoor unit failure
54
Diagnosis and action
1. Replace main remote controller circuit
board.
1. Check the connections to the wireless re-
ceiver and FTC have not become loose and
that the connecting cable is not damaged.
2. to 4.
Turn the power to the indoor unit OFF and
then ON.
Power to both the indoor unit and outdoor
units should be switched OFF then ON.
(This may require switching 1 or 2 breakers
depending if the unit is powered indepen-
dently from the outdoor unit).
If the J0 code is still displayed the FTC and/
or the wireless receiver circuit board should
be replaced.
1 Check and replace the battery if necessary
the wireless remote controller battery.
2. to 4.
Reposition the wireless remote control
closer to the receiver and perform a
communication test.
For procedure refer to wireless remote
controller installation manual.
If "OK" is displayed then the cause of the
J1 to J8 error was the controller was out of
range of the receiver.
The wireless remote controller should be
installed within range of the receiver.
If "Err" is displayed replace wireless remote
controller with a new controller and perform
the pairing procedure.
If after this procedure the "Err" code is still
displayed the fault is with the receiver unit
(attached to the indoor unit).
The receiver unit should be replaced with a
new part and the original remote control can
be reconnected.
If "OK" is displayed then the fault is with the
remote control and this should be replaced.
Refer to outdoor unit service manual.