How To Remove The Side Panels; V/M Plate; How To Remove The Drain Pan - Mitsubishi Electric EHST17D-VM2D Service Manual

DISASSEMBLY PROCEDURE

22. How to remove the side panels

(1) Remove the front panel. (Refer to Procedure 1.)
(2) Remove the 4 screws on the top panel, and remove the 2
screws that hold the top panel onto the back panel.
(Photos 22-2 and 24-1)
(3) Remove the side panel (right) by removing the screw fix-
ing the side panel (right). (Photo 22-1)
(4) Remove the side panel (left) by removing the screw fixing
the side panel (left). (the front side and the back side.)
<V/M plate (Only EHPT20X-MHEDW model)>
(1) Remove the V/M plate by removing 5 screws fixing on the
side panel (Right). (Photo 22-1)
<Only E**T30* series>
(1) Remove the front panel top and under.
(2) Remove the side panel top.
(3) Remove the side panel under.
Photo 22-2
Screws

23. How to remove the drain pan

(1) Remove the front panel. (Refer to Procedure 1.)
(Remove the front panel under only for ER*T30* series.)
(2) Remove the side panel left. (Refer to Procedure 22.)
(Remove the side panel left under only for ER*T30*
series.)
(3) Remove the water pump (primary circuit) / pump valve /
strainer valve. (Refer to Procedure 5.)
<ER*T**X series>
(4) Remove the pump stay.
<ER*T**C/D series>
(4) Remove the plate heat exchanger (P-HEX). (Refer to
Procedure 10.)
(5) Cut the band at the end of the hose connected to the
drain pan. (Photo 23)
(6) Remove the hose from drain pan. (Photo 23)
(7) Lift up and remove the drain pan. (Photo 23)
<CAUTION>
Do not let the drain hose curve upwards.
OCH714A
Top panel
PHOTOS/ FIGURES
Photo 22-1
Side panel
(Left)
Screws
Screws
Photo 23
Band
Drain hose
82
Side panel (Right)
Screws
Screws

V/M plate

Band
Drain pan