Seco Q7-C25 User Manual page 33

Table of Contents

3.2.11

DP interface signals

As said previously, the NXP i.MX 8M processor has an HD Display Transmitter Controller (HDMI TX), which offers multi-protocol support of standards, such as Display

Port 1.3 interface. Therefore, the TMDS interface signals are shared with the signals for the DisplayPort interface.

If the board purchased is in DP configuration, then the following signals will be available on Qseven

DP_LANE3+/DP_LANE3-: Display Port differential pair #3.

DP_LANE2+/DP_LANE2-: Display Port differential pair #2.

DP_LANE1+/DP_LANE1-: Display Port differential pair #1

DP_LANE0+/DP_LANE0-: Display Port differential pair #0

DP_AUX+/DP_AUX-: Display Port auxiliary channel differential pair.

DP_HPD#. DisplayPort Hot Plug Detect Input signal. +3.3V_RUN

specifications until rev. 1.2, while it has been deleted with Qseven specifications rev. 2.0, since the Hot Plug signal for Display Port had been merged with the HPD

signal for HDMI. Qseven

specification Errata Sheet for version 2.0, published by SGET consortium, reintroduced this signal for compatibility with Qseven

Rel 1.2 compliant.

DP and HDMI interfaces share the same pins on Qseven

needs to load a dedicated boot.

Please refer to the following schematics as an example of implementation of multimode DisplayPort connection on the carrier board, which will allow the use of external

adapters for the conversion to HDMI/DVI.

Q7-C25

Golden Finger Connector. Default SW for Q7-C25 is for HDMI support, to have DP support customer

golden finger connector:

-up resistor. This signal was present on Qseven

modules

Table of Contents