Table of Contents
Advertisement
Alternative APMM Power Module Installation - CalAmp LMU 3640 continued...
STEP FOUR
Plug the 16 pin plug from the short end of the
APMM harness into the LMU DIAG port on the
power module.
STEP FIVE
Plug the 6 pin plug from the APMM harness into
the AUX 1 port on the power module.
STEP SIX
Plug the diagnostic cable (from STEP ONE) into the
VEHICLE DIAG. port on the power module.
STEP SEVEN
Plug the usb adapter cable into the 10 pin port on
the side of the power module.
STEP EIGHT
Conect the usb adapter cable to the USB end of the
camera USB power cable. Connect the power end
to the camera (pictured on p11.)
PedigreeTechnologies.com | Support: (701)-499-0022
APMM Harness
Power Module
9
CameraView
Front Facing
Power Module
Diagnostic Cable
Camera USB
Power Cable
Advertisement
Table of Contents
