Table of Contents
Advertisement
Alternative Option - APMM Power Module Installation for Cab-Mate One
STEP ONE
Identify and record the ESN of the Cab-Mate One
before proceeding. The following steps will cover
the serial number and you will need it for activating
the device later, or servicing the device in the future.
STEP TWO
For new intalls of the Cab-Mate One, install
the diagnostic data cable as per the Cab-Mate
One installation document. DO NOT CONNECT
DIAGNOSTIC CABLE TO CRADLE YET
STEP THREE (for new Cab-Mate One installs)
Remove the ball mount from the Panavise mount.
With the other side (the long piece) locate the
desired position on the dash of vehicle and secure
with hardware.
Secure to Dash
STEP THREE (for previously installed Cab-Mate One)
Remove the ball mount from the Panavise mount and remove from the back of the tablet by
removing the 4 fastening screws.
STEP FOUR
Dry fit CameraView module as per the installation instructions (page 3 of this document), routing
the USB cable to the Cab-Mate One, but do not plug it into the APMM module yet.
PedigreeTechnologies.com | Support: (701)-499-0022
Panavise Mount
5
CameraView
Front Facing
Secure to tablet in
step five
Advertisement
Table of Contents
