Table of Contents
Advertisement
Installation Steps, Continued
Standard Direct Wire Installation
STEP ONE
Connect the ground (black) wire of the direct wire harness to DC chassis ground.
•
It may be necessary to crimp a ring terminal to the ground wire.
•
Always connect the ground wire to an already established ground stud when possible.
•
The frame of the vehicle is an acceptable ground point if ground studs are not available.
•
The surface area must be clean and free of paint, rust, or anything that will cause the
connection to fail.
STEP TWO
Connect the power (red) wire to ignition (or other 12V power source that is powered on when the
ignition is on).
(Optional) Power to Fuse Tap
It may be necessary to connect the power wire to a
blade fuse adapter.
•
Crimp the power wire in the open end of the
adapter
•
Remove the ACC fuse and insert it into the fuse
adapter (maximum 10 Amps)
•
Plug the adapter into the open ACC fuse slot
STEP THREE
Connect the micro USB cable to the camera.
PedigreeTechnologies.com | Support: (701)-499-0022
Red - Power
4
CameraView
Front Facing
Black - Ground
Advertisement
Table of Contents
