Advertisement
TO CONNECT WATER SUPPLY
NOTICE: Read carefully before performing this step.
For supply installation, refer to the instructions packed
with the shut-off valve. Carefully bend the tubing to fit.
Cut the tubing end 1/4" longer than the distance between
the shut-off valve and the supply shank. Remove any
burrs from inside the tube.
Slip the coupling nut, compression nut, and ferrule onto
the tubing. Insert the tubing into the shut-off valve and
supply shank, positioning the seal washer (supplied) or
compression
washer
Handtighten the coupling nut, and then tighten the
compression nut.
WARNING: Risk of external leakage. The fill
valve nut has been factory-tightened to design
specifications. If re-tightening is required, wrench
tighten one turn past finger tight.
Turn the shut-off valve "On" and check for leaks. If the
connections are squarely assembled, a slight retightening
of the nuts will stop any leaks.
If the toilet is leaking between the tank and bowl, carefully
retighten the three tank bolts evenly. Check all bowl and
tank connections for leaks for several days.
OPERATION NOTES:
S
The long handle actuates the 1.6 gallon flush for
typical solid waste removal.
S
The short handle actuates the 1.1 gallon flush for
light waste and liquid waste.
Flush the toilet twice, once with the 1.6 gallon flush
handle, and once with the 1.1 gallon flush handle.
Compare the flushing action between the two flushes. The
1.6 gallon flush should be similar to the 1.1 gallon flush
except extended in time and flush action.
FLUSH MECHANISM
NOTE: Be sure the 1.1 gallon (short) and 1.6 gallon
(long) flush chains are attached to the correct arms and
cam locations. See the illustration at right.
If the two arms are not in alignment, turn the adjustment
screw until the arms line up.
Kohler Co., Kohler, WI
(not
supplied)
as
shown.
Supply Shank
Seal Washer
Tubing
Coupling Nut
Compression Nut
Ferrule
Shut-Off Valve
Fig. #8
Long Flush
Handle
Short
Flush
Handle
Long
Flush
Adjustment
Arm
Screw
Short Flush Chain
Short Flush
Attachment
Cam
5
Supply Shank
Compression Washer
Tubing
Coupling Nut
Compression Nut
Ferrule
Shut-Off Valve
Fig. #9
Short Flush Arm
Long Flush
Chain
Long Flush
Attachment
Fig. #10
CA
114107-2-
(B)
Advertisement
