Page 2
Table of Contents CAUTIONS AND WARNINGS..............3 Specifications..................5 Thank You For Choosing Kohler Company..........6 Control Panel................... 6 Operation ....................7 Preparation Before Initial Operation ............9 Test the Functions....................10 Care and Clean..................11 Clean the Spray Wangs ................12 Remove the Seat ..................
Page 3
Children are not allowed to use or touch this product. Do not leave children alone in a room with such product. Kohler Co. 1305685-MY01-C...
Page 4
□ recommended by Kohler Co. Do not lean on cover when use this appliance to prevent product from damage. □...
Page 5
OFF, adjustable 3 dials (ambient temp, about 31-39°C) About 300s Thermal fuse UV sanitize Other safety devices Circuit-Breakers Situated at the Side of the Body Seat-on * Power value testing condition: dynamic pressure 0.2Mpa, inlet water temp 15°C. Kohler Co. 1305685-MY01-C...
Page 7
Standby mode: 1. After deactivate water temp (water temp LED OFF), enter standby mode. Meanwhile, minimize the product energy consumption. 2. After activate water temp (water temp LED ON), exit standby mode, water temp heating function recovered. Kohler Co. 1305685-MY01-C...
Page 8
F - Sanitize Auto UV sterilization function will be activated and start sterilizing nozzle when unseated for a long time. No sterilization function shall be activated after this process in another 24hrs. Bidet nozzle UV radiation range 1305685-MY01-C Kohler Co.
Page 9
Ensure if water inlet valve is OPEN. Plug power cord into socket, Bidet seat generate one short beep, wand extend and retract once, side panel backlight blink until initialization completion. Water temp: OFF Kohler Co. 1305685-MY01-C...
Page 10
The contact might not be activated if customer does not sit all way in. Note: It is difficult to activate contact for light weight children. There’s clearance between seat bumper to toilet due to moveable structrure design. 1305685-MY01-C Kohler Co.
Page 12
Hold "female wash or rear wash" button, clean the spray wand with a soft-bristled brush after wand extended completely. Hold "female wash or rear wash" button after nozzle cleansing; wand retracts or wait for wand to auto retract. 1305685-MY01-C Kohler Co.
Page 15
Open cover or add water inside the toilet might avoid the plastic parts yellowing problem caused by backflow air from discharge pipe after residual toilet water evaporated during long-term idle status. Kohler Co. 1305685-MY01-C...
Page 16
E.Thermal protector auto E.Place product within protection activated. ambient temperature for some time. F.None of the above actions F.Contact a Kohler Service correct the symptom. Representative. A.Seat does not detect user. A.Contact seat detecting zone. B.Water supply stop closed.
Page 17
A. Remove heavy object A. The seat sensor is fromthe seat sensor area. covered by an heavy object. unseated. A. The seat sensor might not be able to detect you depending on the way you're sitting. Kohler Co. 1305685-MY01-C...
Page 18
GB/T 26572. *: Indicate only partial product series contains this substance. Note: the information provided is based on the supplier data and Kohler inspection results. The product is designed not to hurt the environment. Under current technology, all hazardous materials have been used in the smallest amounts possible.
Need help?
Do you have a question about the C3-050 and is the answer not in the manual?
Questions and answers