What To Do If - Becker Centronic SunWindControl SWC411 Assembly And Operating Instructions Manual

Assembly and Operating Instructions
Problem
Drive is not functioning,
transmission control
light is not lit.
Drive is not functioning;
transmission control
light is illuminated.
Transmission control
light is flashing.
Automatic control
commands are not
executed.
The system is not
extended automatically
when the sliding switch
is set to "S".
The system does not
extended manually
when the sliding switch
is set to "H" or "S".
22

What to do if ...?

Cause
1. Batteries are dead.
2. Batteries are incor-
rectly inserted.
1. Receiver outside the
radio range.
2. SWC411 is not
programmed in the
receiver.
Batteries are running out. Insert new batteries.
1. Sliding switch not in the
"H" position.
2. The automatic sun
protection function
was interrupted by a
manual command.
1. Sunlight intensity is
below the threshold
value.
2. Wind speed exceeds
threshold value.
Wind speed exceeds
threshold value.
Remedy
1. Insert new batteries.
2. Insert batteries cor-
rectly.
1. Reduce distance to the
receiver.
2. Programme SWC411.
1. Set sliding switch to the
"S" position.
2. Turn the sliding switch
from "S" to "H" and
back to "S".
1. Adjust sun threshold
value.
2. Wait until wind abates.
Wait until wind abates.