Assembly and Operating Instructions
Displays and pushbuttons
Reset
SWC411
-
MAN/AUTO Sliding Switch
When the sliding switch is set to H, manual control commands (e.g.: UP, STOP,
DOWN pushbutton commands) are executed and an alarm signal (e.g.: wind
alarm if wind sensor is integrated) given.
When the sliding switch is set to S, automatic control commands are executed
(e.g. sun protection function, ...).
The automatic sun protection functions are interrupted if a manual operation is
executed during automatic mode. These functions are re-activated automati-
cally when the programmed threshold values are exceeded or undercut after
retraction or via switching the slide switch from "S" to "H" and back to "S".
16
+ -
+
Functions
RETRACT button
STOP pushbutton
EXTEND button
Wind threshold control switch
Sun threshold control switch
RESET-button
Transmission control light
MAN / AUTO Sliding Switch
Setting aid
Battery compartment
Programming pushbutton