Factory Setting - Becker Centronic SunWindControl SWC411 Assembly And Operating Instructions Manual

Assembly and Operating Instructions
Sun threshold control switch
This control switch allows you to set the sun threshold values (approx. 2KLux
to 100KLux).
The sun threshold value can be set to 15 different levels. If you turn the control
switch slowly, the tubular drive makes a clacking sound for each level.
- Left limit stop = Level 1: extend when sun intensity is low
+ Right limit stop = Level 15: extend when sun intensity is high
If the threshold values are changed, these are adopted immediately.
Note
Please ensure that no buttons are pressed when setting the threshold
value.
If the sun intensity rises above the preset sun threshold, the sun pro-
tection system is extended after approximately 3 minutes. The sun
protection system is retracted again automatically if the sun intensity
remains below the sun threshold for approx. 15 minutes.
TEST mode
The TEST mode is activated by adjusting the threshold value.
This mode will automatically end after approx. 15 minutes. Alternatively, the slid-
ing switch can be used to deactivate the test mode immediately.
In the TEST mode, the times for the sunshade function and wind control are
reduced.
Sun threshold value: Intermediate position (35KLux)
Wind threshold value: Left limit stop (2 m/s) Intermediate position
18

Factory setting