Factory Default Settings - Becker Centronic SunWindControl SWC442-II Assembly And Operating Instructions Manual

When setting the threshold, ensure that no button is
pressed. If the set sun threshold value is exceeded, the sun
protection system extends after a delay of up to 5 minutes.
The sun protection system automatically retracts after the
sunshine level has been continuously below the threshold
value for about 15 minutes.
TEST mode
The TEST mode is activated by adjusting the threshold value. It automatically
ends after about 15 minutes. In TEST mode, the time for which the wind is
monitored is shortened.
Light control button
The light control button allows you to switch the lighting equipment on or off,
and to dim it.
If the light control button is held down for less than about 0.5 seconds, the
lighting equipment will switch ON or OFF.
If the light control button is held down for longer than 0.5 seconds, the lighting
equipment dims according to the command sequence of maximum value,
minimum value, etc.

Factory default settings

Sun threshold value
Wind threshold value
22 - en
Medium setting (about 25 kLux)
Left stop (about 2 m/s)