Using The Stationary Lifter; Remote Control; Power Pack; Safety And Limitations - Pronomic 90P Original Instructions Manual

3 Using the Stationary lifter

If the load is left on the stationary lifter for some time it may be necessary to lower the load
before it can be raised.

3.1 Remote control

The load carrier is raised and lowered by pressing the buttons on the remote control. The remote
control has either two or four buttons and is used as shown below.
The remote control should be placed to allow the user to easily press the buttons.

3.2 Power pack

Modifying the power pack is dangerous. It should not be exposed to splashed or running water.
Turn of the power pack when not in use.

4 Safety and Limitations

Use the protective equipment (e.g. protective footwear) required to handle the goods.
The stated maximum load may not be exceeded.
The stationary lifter must not be used for lifting people.
Note the crush hazard between the load carrier and fixed objects or floor when raising and
lowering the load carrier. Do not keep hands or other body parts under the load.

4.1 Limitations

The column and slide is not designed to withstand horizontal force such as impacts with loads
exceeding the loads presented in the load diagram in this manual. Make sure the equipment is
protected especially from impacts far out on the load carrier.
________________________________________________________________________________
Up/down
5 – Stationary lifter (90/125/130/175/225P)
Up/down
Slowly up/down