Mitsubishi Electric AE-200A Instruction Book page 13

4-2-1. Procedures for making the settings to use this function for the first time
(1) To activate the Operation Data Acquisition function, select [Normal], and then click [Save Settings].
AE-200/AE-50/EW-50 will start acquiring model information of the connected units.
(2) About ten minutes later, click [Refresh].
The addresses of the units that support the Operation Data Acquisition function will appear with a gray
background.
(3) Select the addresses of the units whose operation data are to be collected. The selected addresses will be
highlighted in green.
If you select the wrong address, click the selected address again to deselect. Once the address is
deselected, the background will appear in gray.
Click [Save Settings] to collect the operation data of the selected units.
4-2-2. Procedures for changing the settings for this function
(1) Backgrounds for the addresses whose operation data are being collected will appear in green, for the
addresses whose data are not being collected will appear in gray, and for the addresses not registered to
AE-200/AE-50/EW-50 will appear in black.
The currently selected acquisition mode will appear selected in the Acquisition Mode field. ([Normal] should
be selected by the overseas sales office users.)
(2) Select the addresses of the units whose operation data are to be collected. The selected addresses will be
highlighted in green.
If you select the wrong address, click the selected address again to deselect. Once the address is
deselected, the background will appear in gray.
Click [Save Settings] to collect the operation data of the selected units.
WT07324X02
13