Error Messages - Worx Landroid WR147E.1 Owner's Manual

Quick reference

ERROR MESSAGES

Sometimes things can go wrong. Fortunately Landroid is smart enough to tell you if it is enountering an issue, so you can fix it. If in doubt,
please visit our website where you will find useful videos and further support.
MESSAGE
Outside working area! Press START to
reset.
WRONG PIN! Please retry.
Blade motor fault! Press START to reset. Blade disc is blocked by an object, e.g.
Wheels motor fault! Press START to
reset.
CAUSE
Landroid cannot find the boundary wire
signal.
PIN code is wrong.
a branch.
Blade is over-loaded by thick dense
grass.
Wheel motor is blocked in some way.
ACTION
1. If Landroid is actually outside of its
working area: turn power off, take
Landroid inside the working area, turn
the power on and press start.
2. If Landroid is inside its working area
check if the LED on the charging base is
solid green. If red, check if the boundary
wire is properly connected to the
charging base and that the base is
connected to a suitable power supply.
If they are properly connected, the
boundary wire terminals are clamped
incorrectly and must be reversed.
Input the correct PIN or re-set your PIN.
Turn power off.
Turn Landroid upside down and check
if there's anything preventing the blade
disc from rotating and remove any
obstruction.
Turn Landroid upright.
Turn power on. Press start.
Turn power off.
Take Landroid to an area with short
grass or adjust the cutting height to a
higher setting.
Turn power on. Press start.
Turn power off and take Landroid to an
area free from obstacles.
Turn power on. Press start.
If the error message is still displayed,
turn power off. Turn Landroid
upside-down and check if there's
anything preventing the wheels from
rotating.
Remove any obstruction, turn Landroid
upright, turn power on.
EN
30