Worx Landroid WR147E.1 Owner's Manual page 18

Getting started
Final steps
The boring part is over! There are only a few more steps to go:
• Connect the charging station to the AC mains socket (fig. 13)
• If everything is fine, the LED will light green
• If there's a trouble in the loop, such as broken wire or wire ends not properly clamped, the LED will turn red. Check that everything is
fine and see the FAQ session if the problem persists
13
• Open the rear of Landroid and insert the PowerShare battery into the slot until it clicks (fig.14)
14
CLICK!
• Place Landroid on charge by making sure a good contact is established with the base (fig. 15). The LED will blink green; once the
battery is fully charged, the LED will turn solid green.
15
Let Landroid charge the battery for a while. Whilst it is charging you may want to take a well-deserved break: get familiar with the following
instructions, and connect Landroid to your Wi-Fi network.
EN
18