Getting Started - Worx Landroid WR147E.1 Owner's Manual

Getting started

INSTALLING LANDROID YOURSELF?
EASIER THAN YOU MAY THINK
Installing your Worx Landroid is easier if you carefully follow these instructions. In the end, it is a matter of installing the charging station
and laying the boundary wire all around your lawn. In addition to this manual, you can use the Get Started guide that's inside the box and
watch the comprehensive video tutorials on our YouTube channel*.
* This information is provided for your convenience but does not replace the instruction manual and the safety instructions that needs to be read and understood.
Patrol your
lawn to plan
installation
EVERY MINUTE SPENT IN PLANNING SAVES YOU 10 MINUTES IN EXECUTION
Installing Landroid is even easier if you have made a clear idea of what you need to do. A proper planning will also help you avoid
mistakes or having to rework the installation once it's done.
On the surface or buried?
Landroid's boundary wire is designed to stay on the surface of your lawn. Nearly invisible from the first day, it will be engulfed in the soil
in a few weeks. If you will want to bury the wire, it is recommended to first peg it down and test the installation is successful by running
Landroid over the perimeter. This allows you to easily check everything and, if necessary, change the layout before burying the wire. Bury
the wire no more than a few centimetres below ground level, so that the wire ensures good signal.
Plan for the charging station
The charging station, composed of the base plate abnd the charging tower, is where your Landroid goes to have its battery recharged.
It's also the parking lot where it rests in between one mowing session and the next.
Locate a proper position for it, bearing in mind:
• It needs to be powered, so it should be no more than 10m away from an AC mains outlet
• If possible, choose a shaded position as batteries and chargers don't like over-heating
• The base needs to sit on flat land to ensure effective docking
• Avoid places close to irrigation sprinklers
Install the Lay the
charging boundary
station wire
Power up
Connect
Landroid.
charging
Test and get
station to AC
ready to mow
EN
12