3-3. Troubleshooting (BKDS-7015)
3-3-2. Connecting the Test Terminal with Connector to This Unit
3-3-2. Connecting the Test Terminal with Connector to This Unit
Connect the terminal with described in the section 3-3-1 and the "TERMINAL 1" D-sub 9-pin connector
on the connector panel of the unit.
For the connection, use the cable with satisfied the following specifications.
Signal name
n
The RXD (receiving data) and the TXD (sending data) of (*1) are the sending and receiving signals from
this unit. The RXD (receiving data) and the TXD (sending data) of (*2) are the sending and receiving
signals from the terminal. Therefore, the RXD of (*1) is connected to the TXD of (*2), and the TXD of
(*1) is connected to the RXD of (*2).
3-12
This unit side
[TERMINAL 1]
Pin No.
(*1)
DCD
1
RXD
2
TXD
3
DTR
4
GND
5
DSR
6
RTS
7
CTS
8
RI
9
Terminal side
Signal name
(*2)
DCD
RXD
TXD
DTR
GND
DSR
RTS
CTS
RI
DVS-7200AE MMP1