Installing Memory - HP x4000 Accessory Installation Manual

Figure 2-10 Replacing or Upgrading Memory
1 Pair of RIMMs
CRIMM
RIMM 1A
P1 - edge
3 Pairs of RIMMs
RIMM 2A
RIMM 1A
CRIMM
RIMM 3A
P1 - edge
Note: RIMM 1A and 1B are a matched pair, 2A and 2B are a matched pair,
3A and 3B are a matched pair, and 4A and 4B are a matched pair.

Installing Memory

1. Before turning off your Workstation, check the current amount of
2. Turn off the display and shut down the Workstation. Disconnect all
3. Remove the Workstation's cover (see page 15).
4. To ease installation, place the Workstation on its side with the system
Chapter 2
This manual downloaded from http://www.manualowl.com
CRIMM
RIMM 1B
Memory
Bank I
CRIMM
RIMM 3B
RIMM 2B
RIMM 1B
Memory
Bank II
installed memory. Refer to your operating system documentation for
instructions on finding this information.
power cables and any LAN or telecommunications cables.
board facing upwards.
Installing Accessories
2 Pairs of RIMMs
RIMM 2A
RIMM 1A
RIMM 2B
RIMM 1B
P1 - edge
4 Pairs of RIMMs
RIMM 2A RIMM 4B
RIMM 1A RIMM 3B
RIMM 4A RIMM 2B
RIMM 3A RIMM 1B
P1 - edge
System Memory
29