Figure 2-11 Inserting RIMMs and CRIMMs
9. Replace the MEC (see page 26).
10. Replace the chassis beam assembly (see page 23).
11. Close and secure the hard disk drive cage (see page 20).
12. Replace the Workstation cover (see page 18).
13. Reconnect all power cables and any LAN or telecommunications
cables.
14. Start the Workstation and check the Summary Screen by pressing
when prompted to verify the new configuration. The Summary
Esc
Screen displays the amount of memory.
Chapter 2
This manual downloaded from http://www.manualowl.com
Installing Accessories
System Memory
MEC Voltage
Regulator Module
(not on all MECs)
Retaining Clip
fully engaged
31