Graphics Card; Removing A Graphics Card - HP x4000 Accessory Installation Manual

Installing Accessories

Graphics Card

Graphics Card

Removing a Graphics Card

NOTE Uninstall the driver for this graphics card before installing a new
graphics card.
To remove a graphics card:
1. Turn off the display and shut down the Workstation. Disconnect all
2. Remove the Workstation's cover (see page 15).
3. Remove any cables connected to the graphics card on the rear panel.
4. To ease installation, place the Workstation on its side with the system
5. Rotate the hard disk drive cage to the open position (see page 19).
6. Remove the chassis beam assembly (see page 22).
7. Before removing the graphics card:
8. Carefully pull out the card.
9. Store the card in a static bag.
32
This manual downloaded from http://www.manualowl.com
power cables and any LAN or telecommunications cables.
board facing upwards.
• If your graphics card came with a separate graphics retainer beam
as shown in Figure 2-14 on page 34:
a. Remove the screw that attaches the graphics card and the
graphics retainer beam to the rear slot panel.
b. Remove the full-length graphics card retaining screw.
• If your graphics card did not come with a separate graphics
retainer beam, remove the retaining screw as shown in Figure
2-12 on page 33.
Chapter 2