Setting Up The Bass Drum - thomann Millenium Focus Junior Assembly Instructions Manual

4

Setting up the bass drum

The next thing we need are the ten‐
sion rods.
Let's start with the bass drum.
Position the bass drum shell such that the screws of the tom holder point down‐
wards.
Now lay the white resonator head on the shell and put a hoop over it. Both the hoops
are identical so it doesn't matter which one you put on first. Align the white reso‐
nator head such that the "Millenium" writing is parallel to the tom holder. The head
must be lying evenly on the edge of the shell on all sides.
Proceed as follows: Put the washer on the screw and then the claw hook. We need 6
square-head screws per side.
Hand-tighten all six screws. When doing this, tighten the screws in the diagonally
opposite sequence. You only need to tighten the screws slightly, we will be tuning
the drums later on.
Now turn the shell by 180° to mount the transparent batter head.
If you want to dampen the bass drum, now would be just the right time to
put the damper pillow in the shell to do this.
Focus Junior Drum-Set
Setting up the bass drum
9