Advertisement
OPERATION
Before First use
Note that there may be residual water traces in the tank: this is due to quality control testing
and does not indicate a defect with the product.
Filling Water Tank
Note:
Do not remove or cut small rubber air valve on top of Water Tank Cop. Do not turn
unit upside-down when Water Tank is full - some water may leak through the air
valve.
1.
Make sure Steam Control Dial is set to "off" position.
2.
Rotate Water Tank Cap one-quarter turn in "Unlock" direction (counter-clockwise)
indicated by the illustration on cap and remove.
3.
Carefully fill Cup with the maximum amount of water and pour into the water tank
through the fill hole. Repeat up to two more times to fill Water Tank to maximum
capacity (Tank holds a maximum of 380ml of water).
Note:
To significantly reduce mineral build-up and prolong the life of your Multi-Purpose
Steamer, use of distilled or de-mineralised water in the unit is highly recommended.
Refer to Cleaning and Care for more information about mineral build-up.
4.
Replace Water Tank Cap so that thread grooves on the bottom of Cap (FIGURE
9-B) align with tabs inside fill hole (FIGURE 9-C). Press Water Tank Cop down so
that it sits flush with the top of fill hole (FIGURE 9-D). Rotate one-quarter turn in a
clockwise direction (as indicated by "Lock" illustration on Cap) to lock it in place.
Note:
The tube which transfers water from the Water Tank to the boiler is weighted down
with a brass boll. This is an intentional design to improve the efficiency of water usage.
It is normal for this boll to create a rattling sound inside of Water Tank during use. If
the brass ball has come loose, refer to Troubleshooting for directions to reconnect it.
Advertisement
