Table of Contents
Advertisement
Language
The Language menu allows you to select from multiple language options:
1:
Press the [Enter] (
2:
Use the [Increase] (+) or [Decrease] (–) button to highlight the language:
• English
• Français (French)
• Deutsch (German)
• Español (Spanish)
3:
Press the [Enter] (
Relay Delay
Relay Delay allows you to set a delay that the ColorSource ThruPower uses to sequence relays on and
off. This helps minimize the effects of inrush when the system is switching electronic or LED loads on
relays. The time is configured in milliseconds of delay between relay activation.
1:
From the General Settings menu navigate to Relay Delay.
2:
Press the [Enter] (
3:
Use the [Increase] (+) or [Decrease] (–) button to set the delay. The value changes in increments
of 50 ms.
4:
Press the [Enter] (
Inrush Protect
Inrush Protect allows you to turn on or off the Inrush Protect feature. In a system that includes high-
wattage tungsten lamps, Inrush Protect provides a gradual start for the lamps to minimize the effects
of inrush current. The feature gradually increases the voltage over approximately 10 mains cycles when
the state of the lamp is changed from off to any non-zero level.
1:
From the General Settings menu navigate to Inrush Protect.
2:
Use the [Increase] (+) or [Decrease] (–) button to select Yes or No.
3:
Press the [Enter] (
Restore Defaults
Restore Defaults
Are you sure? This
will restore all
settings to factory
defaults.
Yes
No
Resets the following attributes to default status:
• Dimmer Curves – Set to Mod-Square
• DMX Start Address – Set the start address to 1–12 or 1–24, depending on ColorSource model
• DMX Loss Behavior – Reset to Hold Last Look
Y e s
With the Yes menu item highlighted, press the [Enter] (
default status.
Menu structure
) button.
) button.
) button.
) button.
) button.
) button to restore the above attributes to
17
Advertisement
Table of Contents
