Table of Contents
Advertisement
Mode
The Mode menu allows you to select and apply the
output mode to the selected circuits.
D i m m e r
The output will dim according to the curve setting selected in the dimmer Curve menu (see
page 14
). The relay will not close at any level, including at full.
R e l a y
While the control level is below the threshold configured in the Threshold menu, the relay is switched
off. When the control level reaches the threshold, the relay is switched on.
T P A u t o
With ThruPower, dimming is operated between the DMX levels of 0 and 254, while latching the relay
at DMX level 255. TPAuto can be used to allow the configuration of dimming versus relay mode, which
can be stored as part of console show files for consoles that do not have RDM functionality available.
Curve
The Curve menu allows you to select and apply one of
four curves.
The ColorSource ThruPower is capable of dimming or switching multiple load types, including
incandescent, low voltage, and 2-wire fluorescent. You can choose from four output curves:
14
Mode
Dimmer
Relay
TPAuto
Always On
Off
See Threshold on page 16.
Curve
Mod-Square
Linear
Preheat
Fluorescent
ColorSource ThruPower User Manual
Curve
on
Advertisement
Table of Contents
