rada 425-t3 Product Manual page 31

Recommended Content of Maintenance Log
It is recommended that the Maintenance Log should record the following:
Details of valve, location and use, risk level and instructions
Valve make and model
Valve unique identification number
Valve location
Date installed
Application i.e. type of discharge: bath, shower etc.
Risk assessment report number
Risk level found (e.g. vulnerability of patient)
Frequency of critical component replacement
Frequency of temperature monitoring
Responsibility for temperature monitoring
Location of temperature monitoring records
Source of spares and advice
Issue number of Product Manual (Installation, operating and maintenance instructions).
Details of in-service testing and maintenance
Initial commissioning test data (Supply pressures and temperatures, mixed water
temperature, flow rate, result of cold water isolation test, date carried out, signature
of maintenance person).
First in-service test due date
First in-service test data (As for initial commissioning)
Details of any remedial work carried out to valve or supply system
Second in-service test due date
Second in-service test data (As for initial commissioning)
Details of any remedial work, including part replacement, carried out to valve
or supply system
Next in-service test due date
Next in-service test data (As for initial commissioning)
Details of any remedial work, including part replacement, carried out to valve or
supply system.
Note! Local requirements may demand that additional information be recorded.
31