Angelcare AC027 Owner's Manual page 6

PAUSING AND RESTARTING THE SENSOR PAD
• Allows you to pause the Sensor Pad if you remove baby from the
crib, e.g. for feeding or comforting. Ensure to un-pause the Sensor
Pad before putting baby in the crib
TEST THE SENSOR PAD
1. Sources of vibration & movement other than your baby's can be detected by the Sensor Pad
and interfere with the performance of your Angelcare monitor. The
alarm will not sound if it detects movement other than your baby's
2. There are 3 sensitivity settings – low, medium and high. The unit is set
at medium (default) and can be adjusted accordingly
3. The Sensor Pad will detect false movements if you are touching the crib
4. The monitor will produce a Rouse alarm single beep tone designed to
stir baby if no movement has been detected for 15 seconds. If no further
movement is detected, the main alarm will sound at 20 seconds – a series of continuous beeps
SENSOR PAD FOUR CORNER TEST
1. Place the Sensor Pad at the approximate centre of baby's sleeping area and put the mattress
back in place
2. Switch ON the Nursery Unit – check that Nursery Unit and Sensor Pad units are paired
(connected)
3. Immediately pat your hand lightly and continuously on a corner of the
mattress twice for Sensor to detect movement
4. Step away from the crib
5. The alarm will sound from the Nursery and Parent Unit after 20 seconds.
If the Alarm does not sound, ensure everything is setup correctly and
try again; check battery levels on all units, follow the manual for 'NO
ALARMS' – the sensitivity setting may require lowering by a single level
due to other vibrations/movements
6. If the alarm sounds, pat your hand lightly on a corner of mattress twice for Sensor to detect
movement. It may take up to 8 seconds to recognise movement and for alarm to stop
7.
If the alarm continues, even after lightly patting the corner of your mattress twice, adjust the
sensitivity higher and repeat this test
IMPORTANT
• Test your monitor before first use
• Prior to use and on a regular basis (before placing your child in the crib) always check the
Sensor Pad is detecting no movements or vibrations in its environment
• Test your monitor every time you move the Sensor Pad to a different place
6
2