Operation - Art SLA-4 User Manual

OPERATION

Connect source audio material directly into each input channel and set
the channel level controls to provide an appropriate level into each
channels speakers.
NORMAL OPERATION
For a typical four-channel setup, connect the source (mixer, eq, etc.)
outputs into channels one thru four of the amplifier. Connect your
speakers to the outputs on the rear of the amplifier. Be sure that your
front level controls are turned down to their lowest level (full counter-
clockwise). Turn the amp on, and then slowly turn the input level up.
Use the front level controls to regulate the output volume. Be sure not
to raise the volume past the clip level; however, an intermittent clip
signal is acceptable.
BRIDGE OPERATION
Be sure the amp is shut off. Press the appropriate Stereo/Bridge switch
(on the back) to the "in" position. Connect an input signal to channel 1
(when bridging channels 1 and 2) or channel 3 (when bridging
channels 3 and 4). Connect your speaker across the two appropriate
red output-binding posts on the rear of the amplifier. Turn your
equipment on – the amplifier should be the last piece you turn on (be
sure its volume is turned down). Apply an input signal to your amplifier.
Use channel 1 or channel 3 level controls to adjust your amplifier
output level.
14