Download Print this page

Parts Checklist; Hardware Package - QualGear QG-DM-01-022 Installation Manual

3-way articulating single monitor desk mount

Advertisement

NOTE
Please read the entire installation manual before you start assembly and installation.
WARNING
• Do not begin the installation of this product before you have read and understood
the instructions and warnings contained in this installation manual. If you have
questions regarding the instructions, please contact the reseller or QualGear
department via email at support@qualgear.com.
• This mounting bracket was designed to be installed and utilized ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• Make sure that the supporting surface will safely support the combined weight
the equipment and all attached hardware and components.
• This product should only be installed by someone, who has good mechanical
ability with prior experience in installation and assembly of products and fully
understands this manual.
• Always use an assistant or mechanical lifting equipment to safely lift and position
the equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage
to the items. This greatly reduces their holding power.
• All QualGear products are intended for indoor use only and any outdoor use voids
the limited warranty.
• All QualGear products are designed and tested for residential use only and
commercial use voids the limited warranty. For warranty information, please visit
qualgear.com/warranty.php.
1

Parts Checklist

IMPORTANT:
are included. If any parts are missing or damaged, contact your local distributor or
support@qualgear.com for replacement parts and do not start assembly and installation
until you receive all the parts.
all
any
support
of

Hardware Package

Cable Clip (x1)
any
M3x12mm (x4)
Before starting installation, please check that all parts shown in this checklist
Adapter Bracket
Assembly (x1)
A
Pole (x1)
B
Base Plate (x1)
D
E
5mm Allen Key (x1)
I
M4x12mm (x4)
M5x12mm (x4)
M-A
M-B
M-C
Desk Clamp
Assembly (x1)
C
Silicone Pad (x5)
M10x20mm (x1)
F
G
6mm Allen Key (x1)
J
D3 Washer (x4)
D5 Washer (x4)
M-D
M-E
2

Advertisement

loading