ATH-Heinl Single Lift 35M Operating Instructions Manual page 71

Assembly of the lifting unit (drive kit)
Fit the rear cover (1) using the corresponding screws (2).
Screw the connecting plates (3) to the column. Tighten the screws!
Fit the bracket for the lifting equipment (6) to the column using the supplied screws (7) and
washers (8 + 9).
Connect the hydraulic hoist (10) to the bracket (6) using the screws (11).
Ensure that the steel ball (12) is in the correct position as shown
below.
Connect the lifting equipment (10) to the connecting plates (3) using the supplied
screws (13) and washers (14).
No.
1
2
3
4
5
6
7
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
Description
Cover
M6X10 screw
Connecting plates
M16X50 screw
M16 nut
Bracket for lifting
equipment
M12X30 screw
Manufacturer ATH-Heinl GmbH & CO.KG
No. Description
8 D.12 safety washer
9 D.12 washer
10 Hydraulic hoist
11 M8X18 screw
12 D.20 steel ball
13 M18X45 screw
14 D.18 washer
- 21 -