Rest Risk; Installation; Before Installation; Noise - Nilfisk-Advance Nommo Directions For Use Manual

5.2. Rest Risk

Use of Unit:
• Never use the unit without prior
instructions in use of the unit and its
safety instructions. The instruction
must be prepared by an educated/
instructed personnel.
• Never use the unit without having
read the enclosed guide and safety
instructions.
• Always close water supply after use.
Damaged unit:
• Never use the unit if leakages (water
or chemical) are observed.
• Never use the unit if it is not possible
to operate the closing valves and/or
if it is not possible to select required
operation.
• Never use the unit if it has been
dislodged from its original place of
mounting.

6. Installation

6.1. Before Installation

When the unit is to be mounted you have
to make sure that the carrying capacity of
the wall is sufficient.
The pipeline must be rinsed through
before the system is connected.
Remove cover before the unit is
mounted on the wall.
For safety reasons it is important to read
all of the enclosed information before
installation of this equipment. In addition,
the legislation in force at the time of
purchase must always be considered
in connection with the installation and
mounting of this equipment, no matter
the contents of this manual.If there are
matters of dispute please contact your
dealer.

6.2. Noise

Sound level according to ISO 11202;
Below 70 dB.

6.3. Directions for Mounting

• The unit should be mounted in frost-
free rooms only.
• The unit can be mounted on a wall
or on a separate frame which may
be installed in production areas and
anchored to the floor.
• For mounting on walls, please note
the following:
• The wall for mounting should
be either a stable brick wall or
a wall made of concrete.
• The unit must always be mounted
according to illustration 110005640
(see page 71)
13